Engineering Science, B.S.

The Bachelor of Science in engineering science major conforms to the minimum requirements for a Bachelor of Science degree at Hope College and is not accredited by the Engineering Accreditation Commission ofABET. The accredited major can be found under the Major/Minor tab.

The major consists of a total of 36 credits which must include the following courses:

Two semesters ofENGS 080are also required.

ENGS 100 - Introduction to EngineeringCredits:4
ENGS 122 - Introduction to Engineering MaterialsCredits:2
ENGS 150 - Conservation PrinciplesCredits:2
ENGS 170 - Computer Aided DesignCredits:1
ENGS 220 - StaticsCredits:3
ENGS 241 - Circuit Analysis and ApplicationsCredits:4
ENGS 331 - Dynamic SystemsCredits:3
ENGS 333 - Dynamic Systems LaboratoryCredits:1
ENGS 340 - Applied ThermodynamicsCredits:2
ENGS 451 - Introduction to Engineering DesignCredits:3
ENGS 452 - Engineering DesignCredits:3
The remaining credits may be fulfilled through any other engineering courses.
A maximum of only one credit of internship or research may be counted toward the major.
Programming Competency is required and may be satisfied throughENGS 210.

In addition, 28 credits in science and mathematics courses are required, including:

Courses may be substituted for the required courses with prior approval of the department.

PHYS 121 - General Physics ICredits:3
PHYS 141 - Physics Laboratory ICredits:1
PHYS 122 - General Physics IICredits:3
PHYS 142 - Physics Laboratory IICredits:1
MATH 131 - Calculus ICredits:4
MATH 132 - Calculus IICredits:4
MATH 231 - Multivariable Mathematics ICredits:4 and
MATH 232 - Multivariable Mathematics IICredits:4
CHEM 125 - General Chemistry ICredits:3 and
CHEM 127 - General Chemistry Laboratory ICredits:1